ulao Posted April 7, 2016 Report Share Posted April 7, 2016 I started getting 170's at the end of last summer and started flowing the advice on the net. I was pretty sure it came down to a bad board or bad transformer. At this point I have a new back board, new front board, and a new transformer all Working Jandy parts. Prior to this issue I had to replace my sensor. So I basically bought a brand new swg system. Looking for any and all advice here, not sure where to look next? I guess it's possible the sensor is bad because if I have it unplugged I do not get this error on start up. If I plug it in and turn the pool on I get an immediate 170. Quote Link to comment Share on other sites More sharing options...
ulao Posted April 8, 2016 Author Report Share Posted April 8, 2016 This is new? Maybe I should give this a go. http://www.ebay.com/itm/NEW-Jandy-AquaPure-Flow-Sensor-16-cable-R0452500-NEW-FOR-ALL-AQUAPURE-SYSTEMS-/120986961298?hash=item1c2b628592:g:cHoAAOSwQJhUbPGb Quote Link to comment Share on other sites More sharing options...
ulao Posted April 14, 2016 Author Report Share Posted April 14, 2016 That solved all my issues. I guess there are two programming modes and my unit was never on the right mode since I changed my flow sensor 4 years back and the other 2 I had to change out. This new flow kit has both programming modes. Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted April 15, 2016 Report Share Posted April 15, 2016 Jandy/Zodiac has had lots of problems over the years with their sensors. None of which they would admit to...why would they? Sorry we didn't get back to you earlier, but it looks like you have solved your problem. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.