jwbenninger

I drained my Tiger River Manora S/N M-240627 last spring to fix a leak and left it drained all summer. When I went to fill it back up this fall I couldnt get it to heat. I found that there was pretty significant corrosion on the heating elements so I replaced the heater. Still no luck. I traced the wiring out. The heater is wired between two relays soldered into the circuit board. The heater is getting power on one side but the relay (what I assume closes to complete the circuit) is not working. I can jump the wire straight to the neutral wire comming from the GFI and the heater will work fine. Does anyone know what these relays control? Can I just change the relay, or test it? Any help would be greatly appreciated. Thanks, Jim