Jump to content

j_dog

Members
  • Posts

    4
  • Joined

  • Last visited

j_dog's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. Problem solved. It was the cell. Thanks everyone for your help.
  2. It wasn't set for metric. the temp is all over the place. I've seen between 6 to 121 . I did what you said,here is what I got. I did not hear a click. after 30 seconds it went right to 1700. 1700 92 32.8 0.0 100p -0 1.06 A thermometer reads 74 The Nature Soft system was installed Aug. 2001. The cell was replaced May 2004.
  3. The temp was reading 6, now it says 77. that should be close to correct. the pool store said the salt is 3200. I have cleaned the cell and had it tested, they said it works. I explained this to a Goldline tech. He said because the temp was wrong...the cell is bad. Iwas thinking the pc board. I don't want to buy both if I don't have to.
  4. I have a Nature Soft (goldline) setup that is not working. I had the cell (turbo t-15) tested and they said it is working. I had the water tested and the Salt is 3200. The generating light is flashing. the low salt light is on & the inspect cell light is on. The readings are : Salt 1700 Temp 6 cell Volt 32.2 cell current 0.00 desired output 43p instant sal -0 ver. 1.06 I spoke with Goldline. They said the cell is bad because the temp reads 6. They claim the store cant check if the cell reads the temp correctly. I was thinking the problem was the Main PC Board. Any thoughts ??
×
×
  • Create New...