Jump to content

Diceman

Members
  • Posts

    5
  • Joined

  • Last visited

Contact Methods

  • ICQ
    892549
  • Skype
    netdork

Profile Information

  • Gender
    Male
  • Location
    Florida
  • Gender
    Male

Diceman's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. I will not be needing the low speed side of the pumps (They actually only have wires run for high-speed, common and ground. The Grunfos is a 240v pump (I did check to be sure). Which wire is the low-speed side? Is it the red wire?
  2. 1:) Sounds great. It does have a pressure switch on the heater. I have a harness, but will have to replace the ends to match the pins on the board itself. 2:) Yes, one of the temp sensors was cut off when I purchased it. I have another sensor I will replace that one with. 3:) By wiring the circ pump to the ozone, how does it control turning the pump on and off when needed? I APPRECIATE the help a TON on this!!!!!
  3. Anyone? I guess what I really NEED to know is what wire is for the low speed side of the pumps, that is where I can wire the external circ pump to....
  4. Here is the Control board as well: http://www.poolspaforum.com/forum/index.php?showtopic=46615&st=0&p=179790 https://drive.google.com/open?id=0B-ZxEfy0-IstUjV2ci1YSDg5VVk&authuser=0
  5. I have a Balboa pack I bought used to replace the bad board in my current hot tub. My question is this: Previously the tub had: 2 pumps (powering the jets for each side) - These are both 2 speed pumps, but are only wired for single speed right now 1 Ozonator 1 Grundfos 230v Circ Pump 1 Free standing Vertical Heater Now with the new 'used' Balboa SFW150 pack, it controls the same amount of equipment, for the exception of this pack has the Horizontal Heater tube that is attached to the pack. The plumbing is run such that each pump runs the jets for each side and the Circ pump and heater were there own sub-system. Can I use the integrated heater and wire in the seperate circ pump on this pack? If so how would it be wired? Here are the pics of the Balboa MAS300R board and the wiring diagram it has: Wiring: https://drive.google.com/open?id=0B-ZxEfy0-IstZG1CTVZoVFVRdzA&authuser=0 Board: https://drive.google.com/open?id=0B-ZxEfy0-IstSWRKbEZwS2tMNG8&authuser=0
×
×
  • Create New...