Jump to content

r33pwrd

Members
  • Posts

    3
  • Joined

  • Last visited

r33pwrd's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. So I replaced the flow sensor (the style with the little arm that activates a micro switch) and it still does the same FLO error once the spa is up to running temperature. Someone on here must know these better than I do?? Thanks
  2. So long story short this tub has been an ongoing issue for years with a FLO error code. We have had a technician come out about a year and a half ago and paid a lot to have the flo switch replaced and it did not fix the problem. Here is what I have done: -Replaced heater element (it was bad and not related to the FLO error) -Replace filters (also ran without filters) -Replaced both temp sensors as I was getting very high reading (this fixed that problem) -Removed cleaned and reinstalled circulation pump and flow switch. -forced water throughout all the plumbing with a hose So here I am now and the tub works great during warm up but once the spa is asked to maintain a temp it will get the error code FLO. So new water it will run for almost 20 hours while warming up but once I reset the breaker (assuming the water is already at 104) the flo error returns almost instantly. Also when I flip the breaker I have to turn the jets on or it will get the error instantly. I am not against paying a technician but I simply cannot afford (nor justify) spending thousands of dollars on a 15 year old tub. it is a 199 Marqui Euphoria with the Balboa MTS97 heating system. thank you for any help or advise you can lend
×
×
  • Create New...