Jump to content

Aqualink Rs Controller - Buttons All Light Up In Sequence, Nothing Works


Recommended Posts

Hi all,

Hope you guys can help me figure out what is wrong with my Aqualink RS Controller. I noticed my pool pump didn't start up this morning and when I checked the Aqualink control panel, the Auto light was turned on (solid) but no other lights were on. I pressed the button to toggle to Service Mode but it didn't respond. Tried all of the other buttons, again, no response. I tripped the circuit breaker to cut power to the box, waited a few seconds and flipped it back on. All the lights on each button light up at once, and then turn off one at a time, from left to right, in sequence. Kind of like a marque sign or in a wave. It does this over and over again for a couple of minutes. Then they all turn off. I can get it to do anything.

Any ideas of whats wrong?

Thanks,

Alex

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...