Pool and Spa Forum: Pool and Spa Forum -> Installing Bull Nose Tile In Pool

Jump to content

Subscribe to DENIOS3's Blog        RSS Feed
-----

Installing Bull Nose Tile In Pool

18 May 2009
Icon 2 Comments
Posted by  Icon
I am a new member seeking some advise. I had my pool resurfaced and when I got home I found my bull nose tiles on my steps and spa were replaced w/cut 6x6 inch tiles in a diamond pattern. My wife and I wanted our bull nose back so the pool company has agreed to remove the cut tiles on all the horizontal surfaces and install bull nose to all the horizontal edges. What I need to know is what is the propper proceedure for performing these jobs w/out looking like a "patch Job". They are also going to hydrotorque some large divits at the bottom made by cleets.
Back to DENIOS3's Blog →

2 Comments On This Entry

Page 1 of 1

AquanooB Icon

19 May 2010 - 10:06 AM
Hi new member. It sounds to me like they are going to do it as quickly as they can, and will probably cut the "cut 6x6's" tiles back just enough to accommodate the bullnose piece. depending on the tile, there may or may not be a corresponding BN piece available; hopefully there is. don't let them mix and match tiles on you. As far as the procedure, the BN piece should be close to the same thickness as the field tile and should set/install just like the 6x6's, but look a whole lot better!

good luck with that, let us know how it pans out...

Aaron
0

reliablepoolsolutions Icon

30 June 2010 - 12:37 PM
Hi New guy,

As far as replacing the tile, i'm sure it will be fine. Good thing they are doing it very fast, so that the plaster hasn't discolored or anything. They will be able to match colors real well. If you need any supplies check out www.reliablepoolsolutions.com

Good luck,

Rob
0
Page 1 of 1

← September 2010 →

S M T W T F S
   1 2 34
567891011
12131415161718
19202122232425
2627282930  

Recent Entries